Tork Craft | Annular Hole Cutter HSS 40 X 30mm Broach Slugger Bit Shipping_600 precision-ground carbide teeth and a

precision-ground carbide teeth and a Teflon-coating ‘Perma-SHIELD protection’

A 3/8” bearing guide does the following on the edge while cutting the work piece with the router

Apply two thin coats with an Osmo Floor Brush or Osmo Natural Bristle Brush for smaller areas

For best results gently rub with Ultra Fine Steel Wool (Grade 0000) between coats

Overall Length 410mm

Tork Craft | Annular Hole Cutter HSS 40 X 30mm Broach Slugger Bit Shipping_600 precision-ground carbide teeth and aAnnular Hole Cutter HSS 40 X 30mm Broach Slugger Bit One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these